02
01
Current issue

Volume 02, Number 01.

Published January 2026. Four articles spanning 5G performance, IoT-based BTS security, UWB MIMO antenna design, and microstrip patch antennas for 2.4 GHz.

ISSN: [to be assigned] · DOI prefix: 10.XXXX · CC BY-SA 4.0
Featured
Pages 1–5DOI 10.XXXX/jotecs.v2n1p01

Performance Analysis of 5G Network in Urban

Maya Dwi Anita
[Placeholder abstract — replace with real abstract from PDF]. This paper evaluates the performance of fifth-generation mobile networks deployed in dense urban environments, with emphasis on throughput, latency, and handover reliability across heterogeneous cell types. Field measurements are compared against 3GPP Release 16 baseline expectations.
5G · Urban network · Throughput · Latency
Pages 6–12DOI 10.XXXX/jotecs.v2n1p02

Design of a Compact 4×4 Ultra-Wideband (UWB) MIMO Antenna with Quadra Band-Notch Characteristics on FR-4 Substrate for Wireless Communication Applications

Muhammad Rhevin Adilla, Annisa Khairani
[Placeholder abstract — replace with real abstract from PDF]. A compact 4×4 UWB MIMO antenna system is designed on a low-cost FR-4 substrate. The design introduces four independent band-notches to suppress interference from existing narrowband services. Measured S-parameters and envelope correlation coefficient are reported and discussed.
UWB · MIMO antenna · Band-notch · FR-4 substrate
PDF available on OJS →
Pages 13–18DOI 10.XXXX/jotecs.v2n1p04

Multi-Sensor Security System Based on IoT for Detecting Intrusions in BTS Towers

Fanny Julia Rezki, Shinta Marviola
[Placeholder abstract — replace with real abstract from PDF]. A low-cost multi-sensor intrusion-detection system for base transceiver station towers is presented. The system integrates vibration, tilt, and infrared sensors through an ESP32-based IoT gateway with cloud alerting and tamper-resistant enclosure.
IoT · BTS security · Intrusion detection · Multi-sensor
PDF available on OJS →
Pages 19–23DOI 10.XXXX/jotecs.v2n1p03

Rectangular Microstrip Antenna Design On Frequency Range 1 to 5 GHz and Working Frequency 2.4 GHz

Wendra Wendra Satria Utama
[Placeholder abstract — replace with real abstract from PDF]. Design and simulation of a rectangular microstrip patch antenna optimised for broadband coverage from 1 to 5 GHz with a tuned working frequency at 2.4 GHz for WLAN applications. Return loss and radiation pattern measurements validate the design.
Microstrip antenna · 2.4 GHz · Rectangular patch
PDF available on OJS →
Citation example. Anita, M. D. (2026). Performance Analysis of 5G Network in Urban. JOTECS, 2(1), 1–5. https://doi.org/10.XXXX/jotecs.v2n1p01